TipTop Business Web Directories - Add your sites link starting at £1

If you can see this, your browser doesn't understand IFRAME. However, you can click <A HREF="http://www.tiptopweb.info/newsbar/news_bar.php">here</A> to see the news.

Home | Computers And Technology | Security

Fitting A Door Lock Correctly

By: Steve Drumm

It goes without saying, that a door lock plays a big part in the protection of your property. Your home will be more secure if stronger and higher quality door locks are used. Although most locks are easy to install, it is often a bit more difficult to select the best door lock for each specific door. Take into account the design, size and function of your door along with the door lock’s specifications. For example, a small-sized door lock fitted on a substantial door could potentially look awkward and might not serve its use of providing the maximum security in your home.

Installing a door lock is relatively easy, that is, when you possess the correct tools and you know what to do. But, before we go any further, you need first to choose the right door lock for you by using these guide lines below:

Selecting the right door lock for the job:
1. Determine if the door is left or right handed. Stand outside the door and determine where the hinges are fitted. The hinges will be located on your right for those who have a right-hand door, and the hinges are going to be on your left when you have a left-hand door. A number of door locks will fit in any of these arrangements but some will only fit with a particular door hanging. Left only or right only.

2. Determine the width of your door. With this information you can choose a lock that will suit the breadth of your door. The majority of doors which are used in homes have a 1 3/8" thickness while most doors which are used in|used in} commercial establishments have 1 3/4".

3. Check the span between the centerline of the door knob bore hole and the border of the door – this is called the backset of the door lock. If you are planning to fit a standard lockset, then the backset should normally be 2 3/8" or 2 ¾". However, some locks are designed to be adjustable and can fit varying backsets.

4. Select the appropriate sort of lock to fit on your door. Commercially available residential doors are typically ready for lock installation which means they have already got holes drilled for locks. A bore hole with a diameter of 2 1/8" is intended for a cylinder lock but if you see a large pocket on the border of the door, it is designed to just accept a mortise lock. However, if your door is customized you can choose whatever kind of lock you wish as long as it serves its purpose well.

Fitting the door lock:
1. Take out the lock template and fasten it to the door. The new door lock should include a paper template which will illustrate where the lock is supposed to be fitted including the positions of your screws.

2. If your door doesn’t possess a pre-drilled hole for your lock, start drilling a hole according to the measurements shown on your paper template. At all times drill pilot holes for the screws too.

3. Position the lock in place. Carry out the instructions provided by the manufacturer to install the lock or, if you happen to have lost it, begin by fitting the latch inside the wall of your door followed by the door knobs. Install and line up the connecting rods, and check whether the tail end of your cylinder is attached to the proper slot on the body of the lock. Fit the screws to secure the door lock in place.

4. If you don’t have an existing lock strike plate on your door frame, make room for one using a chisel. Check the installation guide for instructions and measurements. Finally, fit the screws on the strike plate and check out the lock check that it works.

Article Source: http://articles.tiptopweb.info

I have used many locksmith services over the years and they have never let me down yet. Also, they are cheaper than you may think. Locksmith Balham is the one that I use at the moment because that is the area that I live.

Please Rate this Article

Not yet Rated

Click the XML Icon Above to Receive Security Articles Via RSS!

Additional Articles From - Home | Computers And Technology | Security

Business
Investments
Finance
Real Estate
Home Business
Wealth Building

Food and Drink
Health
Fashion
Recreation
Travel

	Print This Article
	Post Comment
	Add To Favorites
	Email to Friends
	Ezine Ready

Submit Articles
Member Login
Top Authors
Submission Guidelines
Ezine Notifications
Article RSS Feeds

About Us
Link to Us
Contact Us
Privacy Policy
Terms of Service

Vote For Tiptop Web Aritcles Directory - http://www.articles.tiptopweb.info
at Top Article Directory List
Top List

Fitting A Door Lock Correctly addthis_pub = 'ex_plo_rer';

Fitting A Door Lock Correctly